C mount

A C mount is a type of lens mount commonly found on 16 mm movie cameras, closed-circuit television cameras, machine vision cameras and microscope phototubes.

C-mount lenses provide a male thread, which mates with a female thread on the camera. The thread is nominally 1 inch (25.4mm) in diameter, with 32 threads per inch (0.794mm pitch), designated as "1-32 UN 2A" in the ANSI B1.1 standard for unified screw threads. The flange focal distance is 17.526 millimetres (0.6900in) for a C mount.

Merely to say that a lens is "C-mount" says very little about the lens's intended use. C-mount lenses have been made for many different formats. C-mount lenses are built for the 8 mm and 16 mm film formats and the 1/3", 1/2", 2/3", 1", and 4/3" video formats, which corresponds to a range of image circles approximately from 5 to 22mm in diameter.

Depending on the format, the design of the lens and its performance will differ considerably. For example, for the 4/3 format, a 12mm lens is a wide-angle lens and will have a retrofocus design. For the 2/3-inch format, a 12mm lens is "normal" and can have a simple and fast double Gauss layout. For the 1/3-inch format, a 12mm lens is long and can have a telephoto design.

Some TV lenses lack provision to focus or vary the aperture, so may not operate properly with film cameras. Also, some TV lenses may have bits that protrude behind the mount far enough to interfere with the shutter or reflex finder mechanisms of a film camera.

Although C-mount lenses have a back focal distance far too short to be used with 35mm film SLRs or any existing digital SLR, they can be mounted on interchangeable-lens mirrorless digital cameras such as the Micro Four Thirds used by Olympus and Panasonic. However, the vast majority of C-mount lenses produce an image circle too small to effectively cover the entire sensor which has approximately 22mm diagonal, this produces vignetting. The Nikon 1 series and the Pentax Q series can use C-mount lenses without vignetting.

C mount was created by Bell & Howell for their Filmo 70 cine cameras. The earliest Filmos had slightly different mounts, known as A mount, and B mount. C mount was found on Filmo 70 cameras with serial numbers 54090 and higher, probably from about 1926. Soon after, other camera manufacturers adopted the same mount, and it became a de facto standard for 16mm cine cameras.

CS mount

CS-mount has a flange focal distance of 12.526 millimetres (0.4931in), compared to 17.526 millimetres (0.6900in) for a C mount, but is otherwise the same as C-mount, including the fact that lenses for many different formats are made for it. CS-mount lenses are built for the smaller formats, 1/2inch and down.

See also

• T-mount
• Lens mount
• Pentax K-mount
• D-mount
• PL-mount
• S-mount

External links

• . The section "Understanding C-Mount and CS-Mount Standard Mechanics, Optics, and Cameras" discusses the standards and custom machining of C-mount apparatus.
• . Collection of cine optics and photos of them.
• . Selection of Lens and extension ring/tube for machine vision
• . Explanation of C-mount and CS-mount